Today we look at how to make the originaltable of conventional automobile wheel. Production stage of the tire with your hands does not cost much, and it can also be used as a coffee table or benches.
How to make cool table of car wheels
- new or used / tire;
- 2 laps of MDF thickness 6 mm, diameter 55 cm;
- six self-tapping screws;
- glue gun or super glue;
- helical cord 5 meters in length, 10 mm thick;
- Cleaning Cloth for tires;
Clean the tires from dirt with a dry cloth, if the tire is very dirty, wash it and let it dry.
1 Put a circle of MDF on a car tire and make 3 holes on the edges of a 3-ex remote locations, so that the punch penetrated into the rubber.
Use a screwdriver and screws fasten MDF to the bus. Do the same with each of the holes, and repeat steps 1, 2 and 3 on the other side of the tire.
With the help of glue attach one end of the cord in the center of the circle of MDF.
Holding the hand keep glue in a spiral cord, do not forget to use the necessary amount of glue to each circle.
Once you cover the full range of MDF cord, do the same on the edges of a car tire.
Turn the tire and continue to cover her cord until you reach the edge of the second round of the MDF.
Once the cord cover the whole surface of the tire, a pair of scissors, cut the rest of the rope and tightly fasten the end of the cord.
Apply nail polish on the brush and cover the entire surface where the cord was used. Allow varnish to dry completely.
Our ottoman with his hands ready!